Boeing Changes 737 Wiring, Checklists After Airspeed Incidents

By John Croft
Source: AWIN First
December 26, 2013
Credit: Daniel Faget

Boeing has made changes to its Boeing 737 pitot tube heating systems and checklists following an incident report by the Irish Air Accident Investigation Unit (AAIU).

That report, published Dec. 19, details a serious incident in which the crew of a Ryanair Boeing 737-800 on an instrument arrival to the Riga Airport in Latvia in snow and ice conditions on Jan. 7, 2012, experienced divergent airspeed indications and other warnings, including an extended stick shaker activation, with no annunciation of the pitot heater short circuit that was the root cause of the problem.

During the investigation, Ryanair told the AAIU that it had experienced 20 events of unannounced pitot heat failures on its 737-800s in 2012 alone, and that the issue was a “fleet-wide problem” that has occurred on all makes of 737 next-generation aircraft.

“[Ryanair] informed the Investigation that it and other operators had brought the failure of the pitot probe heater warning system to the attention of [Boeing],” the report says. “It stated that [Boeing] had consulted with the Federal Aviation Administration (FAA) and the European Aviation Safety Agency (EASA) who agreed in 2011 that the current rate of unannounced pitot probe heater failures met the FAR 25 requirements and that it was not therefore a safety of flight issue.”

The AAIU’s investigation puts doubt on that assessment. According to the final report, the incident flight, with 140 passengers and six crew members, was descending through 6,000 ft. toward Riga in “poor weather conditions with moderate snow” when the airspeed indications on the pilot and first officer displays began to diverge, causing airspeed disagreement, altitude, engine warnings to activate. Pitot tubes, which measure airspeed, include heating elements to prevent ice from corrupting the measurement. The devices are replaced “on-condition,” and in this incident, the failed unit had been in service for 23,618 hr.

The pilots levelled at 4,000 ft. and delayed the approach to assess the problem using checklists. They later decided that the first-officer’s airspeed was incorrect, and set up for an instrument approach to Runway 18 based on the pilot’s airspeed.

During the approach, the 737’s autopilot and autothrottle disconnected, after which the pilots hand-flew the approach despite the first officer’s stick shaker activating from the later stages of the approach all the way through landing. “The flight crew reported that the noise from the stick shaker was distracting and that it made communications difficult,” says the AAIU. The crew had considered pulling the circuit breaker for the stick shaker to disable the system, but decided to “it was unwise to look for the particular circuit breaker in a dark cockpit and in the prevailing circumstances,” according to the report.

The airspeed divergence was later attributed to a pitot tube heater failure on the first-officer’s side due to a short circuit, a problem that should have tripped a pitot heater failure warning in the cockpit. “The pitot heater failure warning had not activated because the design of the warning system may not detect failures of this nature,” says the AAIU.

As such, the AAIU says the 737 does not meet its Part 25 certification requirements that “heated air data sensors” be monitored and failures annunciated. In this case there were situations where the pitot could malfunction and not provide anti-icing, but still continue to draw enough power so as to not trip the alerting system.

Comments On Articles